(2019-10-21, 22:59)N. W. Perry Wrote: Is there a suitable end part, and how would I go about replacing the beveled end with the non-beveled one?I don't think there is an official non beveled version of 165.dat
You could make one yourself and place it in the donors folder "%appdata%\LDCad\donors"
Then...
- use the normal hose template in your model.
- Go to the hose's own session (double click it in non nested editing mode).
- Go to grouping level 0 (top right session panel).
- Select the cap you want to change.
- Double click it's replacement in the bin.
- Click the coordinate panel or press enter to open the cap's properties and check 'inline'. (this prevents a dependency on the unofficial part)
If you need it often you can make a dedicated template for it by coping the normal one and applying the above steps to the template it self.