Technic 1977


RE: Technic 1977
#16
(2020-03-27, 18:51)aefferen Wrote: Hello N. W. Perry,
Thanks again for your elaborate reply much appreciated.
point 1. After some investigation I understood what you meant. This is fixed now. Further more I am going through the model now part by part and do find several omissions. So lot op corrections to do.
Point 2. Still didn't find in MLcad how to solve that issue. I discovered now what you mean. I did find a function to sow the center point and it is way outside the model. Problem is I don't know how that happened. More work to do.
Point 3. Currently busy to mesh the gears, just to do that for once.
Point 4. I found the guidelines but these are pretty elaborate so need to find a quiet moment to read them.
All in all again a well appreciated feedback.
Best regards Allard
Adjusted file.
1. corrected
2. managed to find out how to correct this. You are right it is much easier to move the 3D model now.
3. Gears are meshed.
4. double checked against the guidelines. Didn't find directions for equipment so left it as it is.


Attached Files
.mpd   851 - Tractor.mpd (Size: 20.55 KB / Downloads: 4)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Technic 1977 - by N. W. Perry - 2019-10-06, 1:03
853/956 - Auto Chassis - by N. W. Perry - 2019-10-06, 1:20
RE: Technic 1977 - by aefferen - 2020-03-20, 18:01
RE: Technic 1977 - by Philippe Hurbain - 2020-03-21, 8:26
RE: Technic 1977 - by aefferen - 2020-03-21, 13:31
RE: Technic 1977 - by N. W. Perry - 2020-03-21, 16:29
RE: Technic 1977 - by Philippe Hurbain - 2020-03-21, 19:39
RE: Technic 1977 - by Orion Pobursky - 2020-03-21, 19:48
RE: Technic 1977 - by N. W. Perry - 2020-03-21, 22:22
RE: Technic 1977 - by aefferen - 2020-03-27, 18:41
RE: Technic 1977 - by aefferen - 2020-03-25, 19:19
RE: Technic 1977 - by N. W. Perry - 2020-03-26, 4:06
RE: Technic 1977 - by aefferen - 2020-03-27, 18:51
RE: Technic 1977 - by aefferen - 2020-03-27, 20:17
RE: Technic 1977 - by N. W. Perry - 2020-03-28, 2:30
RE: Technic 1977 - by aefferen - 2020-04-03, 16:33
RE: Technic 1977 - by N. W. Perry - 2020-04-03, 17:04
RE: Technic 1977 - by aefferen - 2020-03-21, 12:51

Forum Jump:


Users browsing this thread: 1 Guest(s)