Technic 1977


RE: Technic 1977
#5
In equipement 1 the driving axle
Code:
1 0 -25.5 -48 -5 0 -1 0 1 0 0 0 0 1 3705.dat
is placed too high, it collides with top plate and doesn't enter in the hole of bottom plate.

Also, since the model is shown with equipment 1, I think that the attachment beams of tractor should be configured/rotated so that the small wheels of equipment 1 sit on floor (and so that the top 40t gear properly mesh with driving crown gear of tractor)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Technic 1977 - by N. W. Perry - 2019-10-06, 1:03
853/956 - Auto Chassis - by N. W. Perry - 2019-10-06, 1:20
RE: Technic 1977 - by aefferen - 2020-03-20, 18:01
RE: Technic 1977 - by Philippe Hurbain - 2020-03-21, 8:26
RE: Technic 1977 - by aefferen - 2020-03-21, 13:31
RE: Technic 1977 - by N. W. Perry - 2020-03-21, 16:29
RE: Technic 1977 - by Philippe Hurbain - 2020-03-21, 19:39
RE: Technic 1977 - by Orion Pobursky - 2020-03-21, 19:48
RE: Technic 1977 - by N. W. Perry - 2020-03-21, 22:22
RE: Technic 1977 - by aefferen - 2020-03-27, 18:41
RE: Technic 1977 - by aefferen - 2020-03-25, 19:19
RE: Technic 1977 - by N. W. Perry - 2020-03-26, 4:06
RE: Technic 1977 - by aefferen - 2020-03-27, 18:51
RE: Technic 1977 - by aefferen - 2020-03-27, 20:17
RE: Technic 1977 - by N. W. Perry - 2020-03-28, 2:30
RE: Technic 1977 - by aefferen - 2020-04-03, 16:33
RE: Technic 1977 - by N. W. Perry - 2020-04-03, 17:04
RE: Technic 1977 - by aefferen - 2020-03-21, 12:51

Forum Jump:


Users browsing this thread: 1 Guest(s)