LD Pattern Creator Help - Template creation


RE: LD Pattern Creator Help - Template creation
#13
(2019-09-18, 4:29)AdamM Wrote: I forgot to include the .dat file for you to look at if that helps. Attached.

May be your s01 subfile still includes the from face, that does not need to be there.

EDIT: Confirmed, your s01 Subfile contains the front face where the pattern is.

I did not explicitly write that in my notes. This face has to go as it leads to overlapping polygons. See the samples here:
The GREEN one misses (correctly) the front face in the sub-file, the RED one is done like yours, where faces overlap. You can see immediately in the editor viewport that something is wrong:

   

This leads to the following render: (Much better result at the GREEN Brick)
   

I have attached the sample of the relevant sub-file, it needed the line

1 16 0 60 10 -60 0 0 0 0 -60 0 -20 0 box4-1.dat

further broken down to be able to remove the front face (quad), see the file in the attachment, in LDPE it looks like this:
   

As a final note: The pattern could be cleaned up a bit more to reduce the number of polygons, see the sample screenshot:
   


Attached Files
.dat   59439s01.dat (Size: 1.51 KB / Downloads: 2)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: LD Pattern Creator Help - Template creation - by Gerald Lasser - 2019-09-18, 8:05

Forum Jump:


Users browsing this thread: 1 Guest(s)