need help with chains


RE: need help with chains
#4
(2019-08-07, 20:31)Stefan Weinert Wrote: Hi Johann,
i used the only changeable part for chains. I think I used the LQ model like the flex hose, flex axis and cables. How can I find that out in LDCad? If I go to the submodel, I find the following text (see pdf)...
...the bottom picture is the result when i do phillipe's change in nested mode
HI Stefan
I just played a little bit with LDCad and create a new small chain in the front of the truck
After importing to Studio, this chain don't make problems.
Maybe you must create the chains new.
Undecided
Any one else ideas?


Attached Files
.png   Chain.PNG (Size: 91.99 KB / Downloads: 87)
If nothing goes right, go left.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
need help with chains - by Stefan Weinert - 2019-08-07, 15:07
RE: need help with chains - by Johann Eisner - 2019-08-07, 19:44
RE: need help with chains - by Stefan Weinert - 2019-08-07, 20:31
RE: need help with chains - by Johann Eisner - 2019-08-07, 20:40
RE: need help with chains - by Johann Eisner - 2019-08-07, 21:11
RE: need help with chains - by Stefan Weinert - 2019-08-08, 14:06
RE: need help with chains - by Stefan Weinert - 2019-08-08, 14:18
RE: need help with chains - by Roland Melkert - 2019-08-08, 16:57
RE: need help with chains - by Stefan Weinert - 2019-08-09, 14:59

Forum Jump:


Users browsing this thread: 1 Guest(s)