LDraw file generation


RE: LDraw file generation
#4
(2019-07-29, 19:30)Roland Melkert Wrote: You could do this with LDCad's scripting, that way you won't need to worry (much) about the matrix math.


The matrix in the type 1 lines always works with the abs origin (0,0,0) of the part/submodel it references.
 (MUCH)!!!
I'm also thinking along those lines.
But the same problem arises and that is computing where the center of the brick that you just turned is located. I believe, once you turn the brick (in the connected row), you have to know where the new center of the next brick is located and adjust it slightly, before you do the next rotation.
I have found that when I manually turn a brick wall, of lets say 32 segments, the computed amount (11.25 degrees) for each segment, the final result needs editing to accurately join with the originating segment.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
LDraw file generation - by Ed Bardet - 2019-07-29, 15:41
RE: LDraw file generation - by Roland Melkert - 2019-07-29, 19:30
RE: LDraw file generation - by Travis Cobbs - 2019-07-29, 19:50
RE: LDraw file generation - by Ed Bardet - 2019-07-29, 21:16
RE: LDraw file generation - by Ed Bardet - 2019-07-30, 20:24
RE: LDraw file generation - by Gerald Lasser - 2019-07-30, 22:10
RE: LDraw file generation - by Ed Bardet - 2019-07-30, 22:14
RE: LDraw file generation - by Travis Cobbs - 2019-07-30, 22:13
RE: LDraw file generation - by Ed Bardet - 2019-07-30, 22:43
RE: LDraw file generation - by Ed Bardet - 2019-07-31, 11:21
RE: LDraw file generation - by Ed Bardet - 2019-07-31, 21:55
RE: LDraw file generation - by Willy Tschager - 2019-08-02, 16:30
RE: LDraw file generation - by Orion Pobursky - 2019-08-02, 16:40
RE: LDraw file generation - by Willy Tschager - 2019-08-03, 10:01
RE: LDraw file generation - by Johann Eisner - 2019-08-03, 10:26
RE: LDraw file generation - by Ed Bardet - 2019-07-31, 22:00

Forum Jump:


Users browsing this thread: 1 Guest(s)