Ldcad part alignment


RE: Ldcad part alignment
#11
(2019-04-21, 22:01)tatubias Wrote: i was able to remake the part, using relative grid and was much faster it took me a pair of minutes. but as you can notice, this brick has an angle of 157.5 degrees, the default grid cant make smalers steps that 1°

so we can only make an aproximation, by the moment if good for me Wink

thank you very much.

Do you have part snapping on? Mouse over the grid and see if it says ps or gs

.jpeg   88E48E19-43D5-42F8-B390-4B2A09E8CB09.jpeg (Size: 30.97 KB / Downloads: 173)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Ldcad part alignment - by Victor Di Rienzo - 2019-04-17, 22:39
RE: Ldcad part alignment - by Roland Melkert - 2019-04-18, 16:18
RE: Ldcad part alignment - by Orion Pobursky - 2019-04-20, 15:07
RE: Ldcad part alignment - by Orion Pobursky - 2019-04-21, 23:20
RE: Ldcad part alignment - by Magnus Forsberg - 2019-04-22, 10:29
RE: Ldcad part alignment - by Magnus Forsberg - 2019-04-22, 12:02
RE: Ldcad part alignment - by Roland Melkert - 2019-04-23, 19:01

Forum Jump:


Users browsing this thread: 1 Guest(s)