Howto treat submodel as inlined in LPub3D


RE: Howto treat submodel as inlined in LPub3D
#5
(2019-04-07, 20:12)David Manley Wrote: Does the attached model achieve what you are aiming for?

It shows;
  1. two bricks as a sub-model done as a callout then
  2. placed on a single brick. Followed by
  3. the same sub-model (but ignored) and then
  4. using the LPUB PLI BEGIN SUB command twwice to insert the two parts from the ignored sub-model
  5. with a single brick, to list the three bricks in the part list
  6. the bill of materials at the end is correct.
David

Hi David,

very interesting, I would never have thought of such an approach. Yes, I think it does achieve what I am aiming for. I am not sure whether I want to apply it large scale, but it's certainly an eye-opener.

Thank you,
Lutz
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Howto treat submodel as inlined in LPub3D - by Lutz Gehlen - 2019-04-08, 19:14

Forum Jump:


Users browsing this thread: 1 Guest(s)