32004b - Need advice.


Re: 32004b - Need advice.
#12
Damien Roux Wrote:Yes, yes. Instead of spending hours to create a part without even being sure the dimensions are correct, I preferred to do it in 10 minutes with a cad software allowing easy changes. Then, will subpart it and create primitives.

I basically figured that out when I reread your original post, which is why I essentially deleted my own post.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
32004b - Need advice. - by Damien Roux - 2011-12-10, 21:43
Re: 32004b - Need advice. - by Damien Roux - 2011-12-12, 21:25
Re: 32004b - Need advice. - by Travis Cobbs - 2011-12-12, 22:17
Re: 32004b - Need advice. - by Damien Roux - 2011-12-12, 23:31
Re: 32004b - Need advice. - by Travis Cobbs - 2011-12-13, 17:07
Re: 32004b - Need advice. - by Damien Roux - 2011-12-14, 8:06
Re: 32004b - Need advice. - by Damien Roux - 2011-12-14, 13:47
Re: 32004b - Need advice. - by Travis Cobbs - 2011-12-14, 17:09
Re: 32004b - Need advice. - by Damien Roux - 2011-12-18, 12:24
Re: 32004b - Need advice. - by Damien Roux - 2011-12-18, 13:10
Re: 32004b - Need advice. - by Damien Roux - 2011-12-18, 19:16

Forum Jump:


Users browsing this thread: 1 Guest(s)