LDCad Rubber band generation

RE: LDCad Rubber band generation
(2018-12-06, 16:34)Philippe Hurbain Wrote: Probably... right-click on the costraint -> properties -> direction -> counter clockwise on XY

(2018-12-06, 16:37)Merlijn Wissink Wrote: That is most certainly possible. I assume you already know how to work with LDCad templates.
You need three control points: 1 for each big wheel each and 1 at the bush in the center.
Then, select the center control point and open the properties (clicking on the little XYZ popup). Then change the Direction from 'Clockwise on XY' to 'Counter Clockwise on XY' and it should do the trick. Or, at least it did for me...

Thank you ! I will try your advice !
« Next Oldest | Next Newest »

Messages In This Thread
RE: LDCad Rubber band generation - by Faramond Florent - 2018-12-06, 16:42
RE: LDCad Rubber band generation - by Shi.Yan - 2018-12-13, 10:18

Forum Jump:

Users browsing this thread: 1 Guest(s)