Using LDCad flexible parts with Studio

RE: 2 - Flexible parts with scaled segments
(2018-11-02, 15:43)Philippe Hurbain Wrote: [Image: scaledflex.jpg]

Is there any similar workaround for using LSynth parts in Studio? I have exactly this issue with the renderer, where the part segments show as disconnected rather than continuous, for the flex system (rigid) hoses. (I'm using Mac, so Bricksmith is my LDraw editor which means LSynth is my option for flexible parts, since Studio's is not usable.)
« Next Oldest | Next Newest »

Messages In This Thread
RE: 2 - Flexible parts with scaled segments - by N. W. Perry - 2019-09-06, 19:54

Forum Jump:

Users browsing this thread: 1 Guest(s)