LPub ROTSTEP - easy rotation?

RE: LPub ROTSTEP - easy rotation?
(2018-04-25, 7:42)Jetro de Château Wrote: One of my biggest problems when using LPub is rotating models to show where a part is attached. I can normally work ut 90º increments in my head, but when it comes down to a more complex rotation I am at a complete loss.

I have seen I can rotate the model using the LeoCAD pane in LPub, but have not found a way to extract the rotation information and use it as a ROTSTEP command. Is there an easy way to do this? There must be a better way to go about this than to punch in some numbers and hope for the best....

I use good old MLCad for complex rotation steps... Big Grin
Jaco van der Molen
« Next Oldest | Next Newest »

Messages In This Thread
RE: LPub ROTSTEP - easy rotation? - by Jaco van der Molen - 2018-05-16, 12:26

Forum Jump:

Users browsing this thread: 1 Guest(s)