MLCad 3.50 is available


RE: MLCad 3.50 is available
#17
(2018-02-20, 20:54)Jaco van der Molen Wrote: Snapping all parts that a minifig can hold and fit in a minifig hand would be nice, not all parts do that.
Since recently I tried to get a minifig to hold a camera, but that part did snap to the hand. This one:
[Image: 2b43bcdc2d40267a560daab82a17c744.jpg]

The snapping point on that has a length of 10 while the minifig hand clip has a length of 12 so the engine (correctly) decides it won't fit Smile

I'll change it to 12 although it will then allow for overlap depending on the orientation of the hand.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
MLCad 3.50 is available - by Steffen - 2018-02-17, 9:23
RE: MLCad 3.50 is available - by Steffen - 2018-02-18, 16:38
RE: MLCad 3.50 is available - by Steffen - 2018-02-19, 1:01
RE: MLCad 3.50 is available - by Steffen - 2018-02-18, 16:37
RE: MLCad 3.50 is available - by Roland Melkert - 2018-02-20, 21:24
MLCad 3.51 is available - by Steffen - 2024-02-06, 14:05

Forum Jump:


Users browsing this thread: 1 Guest(s)