[LDPartEditor] 0.8.31 Beta Released (!LPE VERTEX / Usability / bugfix)


RE: [LDPartEditor] LDPE Edger2 bug?
#7
Looks like LDPE embedded Edger2 sometimes creates erroneous edge lines in flat areas... Attached the original file, result with command line Edger2, result with LDPE Edger2. Problem occurs near the tread rounded tips of tread. Default parameters, no generation of unmatched lines.

Found the culprit: overlapping surfaces. I was fooled because minute rounding errors made these overlaps unnoticed by LDPE duplicate detection engine.


Attached Files
.dat   228-2500-1917s01.dat (Size: 45.62 KB / Downloads: 2)
.dat   228-2500-1917s01edger2.dat (Size: 21.71 KB / Downloads: 0)
.dat   228-2500-1917s01ldpe.dat (Size: 54.48 KB / Downloads: 1)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: [LDPartEditor] LDPE Edger2 bug? - by Philippe Hurbain - 2017-05-23, 11:54
Faster undo/redo (0.8.32) - by Nils Schmidt - 2017-06-15, 11:58

Forum Jump:


Users browsing this thread: 1 Guest(s)