For Beginners: LDCad 1.5 Part Bins for EV3 Education 45544-1


RE: For Beginners: LDCad 1.5 Part Bins for EV3 Education 45544-1
#10
(2016-08-15, 3:08)Walt White Wrote: Hi Owen,

Sorry I didn't reply sooner;  I've been out of town all weekend.

As mentioned in Part 1, I wanted one setup with all the parts in a single bin, plus another setup with all the parts split up into six bins. 

What do you see instead of the screenshots?  This is my first post to this Forum so I just assumed that the screenshot images would be seen by everyone OK.  I'll snoop around for a FAQ about where to host images and fix it.

Walt

Right, but my point was that if you wanted to use more than 6 different categories, you can. You can add another whole part bin window, which gives you six more bins, and you can have two of them displayed at the same time. In my setup, I have a window (6 bins) for studless technic, another window (6 more bins) for studded technic, and a third window (for a total of 18 bins) for everything else - which I mostly use for submodels and misc. non-technic parts. I just wanted to make sure you knew you could do that.

Instead of a screenshot, I see "Image: " then a filename, surrounded by [].
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: For Beginners: LDCad 1.5 Part Bins for EV3 Education 45544-1 - by Owen Dive - 2016-08-15, 7:27

Forum Jump:


Users browsing this thread: 1 Guest(s)