Found two little glitches...
- In the attached file, I colored two rectangle greens. But LDPE shows them as main color, even if LDPE selection window shows that the color is indeed '2'.
- In the same file, if I select the two yellow boxes then select -> touching, the two green rectangles are not selected, though they are touching (that's something I can understand, determining adjacency of 2 subfiles is not easy)
- Stranger, the 3 red lines on the back face get selected, though they are definitely not touching...
- In the attached file, I colored two rectangle greens. But LDPE shows them as main color, even if LDPE selection window shows that the color is indeed '2'.
- In the same file, if I select the two yellow boxes then select -> touching, the two green rectangles are not selected, though they are touching (that's something I can understand, determining adjacency of 2 subfiles is not easy)
- Stranger, the 3 red lines on the back face get selected, though they are definitely not touching...