Smoothing and BFC problems in LDview


Re: Smoothing and BFC problems in LDview
#2
I should propably also mention that I used the 2-8sphe.dat, from the official 'p' library, to test if I could make conitional lines with Edger2. I exported it as "LDRAW Primitives" from MLCAD and deleted the existing edge & condlines from the part.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Re: Smoothing and BFC problems in LDview - by Mikkel Bech Jensen - 2015-02-19, 18:12

Forum Jump:


Users browsing this thread: 1 Guest(s)