Auto correcting (some) defects in the official library


Re: Resulting patch (was Re: Auto correcting..)
#40
My routines aren't really as sophiscated.. I usually just look at the header as displayed by the parts tracker and inspect the part in LDView with the BFC red/green/blue mode on, check the origin, orientation, check in edges-only mode to find missing edgelines and, for patterns, check in random colors too. DATHeader doesn't work on my linux system at all so I just have to hope someone else scans the part.

My rule of thumb generally is that if the origin/orientation is good and the part doesn't show visual deficits and it's technically correct then it's good enough.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Re: Resulting patch (was Re: Auto correcting..) - by Santeri Piippo - 2014-11-21, 14:10

Forum Jump:


Users browsing this thread: 3 Guest(s)