It sounds like you configured LDView to display edges only. (Note: normally LDView is used to generate the model pictures inside LPub.) Run LDView, and check on the Geometry tab of its preferences. Make sure "Show edges only" isn't checked. Then, go to the Preference Sets tab and see if there is an LPub preference set. If there is, select and hit Apply, then verify the "Show edges only" preference is unchecked again. Make sure to switch to some other preference set then, so that changes you make to standard LDView preferences won't effect LPub.
LPub has displaying no colour in the model
« Next Oldest | Next Newest »
| Messages In This Thread |
|
LPub has displaying no colour in the model - by Jono - 2014-03-22, 5:36
Re: LPub has displaying no colour in the model - by Travis Cobbs - 2014-03-22, 21:58
Re: LPub has displaying no colour in the model - by Jono - 2014-03-23, 6:45
|
Users browsing this thread: 1 Guest(s)