Datsville rev328


Re: Datsville rev328
#17
Code:
Technically the files are missing, cause the contents of mpd's can not be shared except of the main model one. So e.g. a 3005.dat in a.mpd can not be used from b.mpd. You need to also add that (probably same) 3005.dat to b.mpd, or write it as a loose 3005.dat in the target folder.
No, they are not missing. They are added to the mpd content file where they are used.
But you are right, best thing would be to write all double files as loose file into the target folder. But to do this, I need to be sure that both files do have really the same content. This could be the solution that I was looking for.
Sometimes it can be so easy Smile

Code:
It might work in LDView if the part is in the top level mpd, but that's because of a bug if I remember correctly.
No bug is needed Smile
I have used in MPDCenter an idea that I had already some years ago.

The attached file should have the extension xmpd, but that is not a valid file extension for upload, so I changed that to plain mpd.
From the structure this is a normal mpd content file. But it contains several mpd files - cooked together in one file Smile


Attached Files
.mpd   datsville328.mpd (Size: 3.3 MB / Downloads: 1)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Datsville rev328 - by Michael Horvath - 2013-12-17, 14:22
Re: Datsville rev328 - by Michael Heidemann - 2013-12-19, 16:53
Re: Datsville rev328 - by Michael Horvath - 2013-12-19, 23:07
Re: Datsville rev328 - by Michael Heidemann - 2013-12-20, 13:50
Re: Datsville rev328 - by Michael Horvath - 2013-12-20, 17:16
Re: Datsville rev328 - by Michael Heidemann - 2013-12-20, 19:17
Re: Datsville rev328 - by Roland Melkert - 2013-12-21, 21:13
Re: Datsville rev328 - by Michael Heidemann - 2013-12-21, 22:53
Re: Datsville rev337 - by Michael Horvath - 2013-12-21, 14:45
Re: Datsville rev337 - by Michael Heidemann - 2013-12-21, 15:14
Re: Datsville rev337 - by Michael Horvath - 2013-12-21, 15:58
Re: Datsville rev337 - by Michael Heidemann - 2013-12-21, 16:08

Forum Jump:


Users browsing this thread: 1 Guest(s)