Micro ball and socket parts


Re: [Parts in Progress] Re: Micro ball and socket parts
#32
The current design of the "joint-8-socket-frica.dat"-primitive is not correct.

If I measure it correct, I find that:
1.)
It should be possible to move the towball ~+/-35 degrees in the horizontal plane.
1 12 -24.574561 -4 -17.207293 0.819152 0 -0.573576 0 1 0 0.573576 0 0.819152 14418.dat
1 14 20 -4 0 0 0 1 0 1 0 -1 0 0 14417.dat
2.)
And if the axle on the towball is placed in a vertical position, it should be possible to move it ~+/-5 degrees.
1 12 -30 -4 0 1 0 0 0 1 0 0 0 1 14418.dat
1 14 -4 -19.923894 1.743115 0 1 0 -0.087156 0 -0.996195 -0.996195 0 0.087156 14417.dat
3.)
There should be a gap between the backside of this socket and a brick placed on top, or bottom, of it.
It isn't big, about 0.5 LDU, but easy to see.
1 12 -30 -4 0 1 0 0 0 1 0 0 0 1 14418.dat
1 14 -30 -12 0 1 0 0 0 1 0 0 0 1 3023.dat

I'm working on a rewrite, from scratch, if you don't mind, Tim.

Maybe someone could help me and verify my measurements?
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Micro ball and socket parts - by Tim Gould - 2013-07-22, 23:50
Re: [Parts in Progress] Re: Micro ball and socket parts - by Magnus Forsberg - 2014-03-19, 17:19

Forum Jump:


Users browsing this thread: 1 Guest(s)