Point matching Re: Question about edges


Re: Point matching Re: Question about edges
#5
Not a partnumber at the moment, but there are many parts that uses primitives (mostly curved) that builds the shape, but not truncated as needed (as that would eliminate the build in smoothing for that primitives) and the egdeline is just generated by isecalc. The remaining part of the primitive just pokes into the inside of the part and is never visible except at parts that can also occur as transparent. Therefore at those parts this technic should be avoided.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Re: Point matching Re: Question about edges - by Michael Heidemann - 2013-03-24, 9:50

Forum Jump:


Users browsing this thread: 1 Guest(s)