Mindstorms Shooterbot Base


Re: Mindstorms Shooterbot Base
#2
Nice start! There are a few problems nonetheless...
- almost all pins are missing
- some parts are slightly misplaced. I see that you used LeoCAD, you should set your grid to half stud in all directions. Have a look at this documentation.
- the model is upside down!
- The tread tracks are not the right ones (but the right ones are not yet official)
- A few colors are wrong
Here attached your model with the last three problems corrected.


Attached Files
.mpd   shooterbot_base.mpd (Size: 2.56 KB / Downloads: 6)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Mindstorms Shooterbot Base - by Tony Miles - 2013-03-09, 1:53
Re: Mindstorms Shooterbot Base - by Philippe Hurbain - 2013-03-09, 8:31

Forum Jump:


Users browsing this thread: 1 Guest(s)