Yep, the (x86) is the program files location for 32bit stuff. The All in One Installer refers to 64bit and that location on the page so I can only assume it has been tested and worked for others. This is my first time though running this setup on this system so I haven't a clue.
I have even tried to run that exe as well as MLCAD in compatibility mode just in case but that didn't work either. I did give all associated files full control in permissions thinking that was it was well, obviously no luck.
This issue is killing me, I need it to work.
I guess the big question is why am I getting this warning - 'C:\Users\J' is not recognized as an internal or external command, operable program or batch file. The system cannot find the path specified.
If I have the correct path and I am getting this warning...
I have even tried to run that exe as well as MLCAD in compatibility mode just in case but that didn't work either. I did give all associated files full control in permissions thinking that was it was well, obviously no luck.
This issue is killing me, I need it to work.
I guess the big question is why am I getting this warning - 'C:\Users\J' is not recognized as an internal or external command, operable program or batch file. The system cannot find the path specified.
If I have the correct path and I am getting this warning...
______________________________________________
OS = Ubuntu 14.04 LTS (64bit)
OS = Ubuntu 14.04 LTS (64bit)