The antialiasing looks really good on the edge lines. Is there a way to get ldview to antialias the edges of the printed polys as well? Alternatively, is FSAA available with the osmesa renderer? Or as a last resort, render at 2x and resample back down with a post processor like imagemagick to smooth out the edges of the printed bits.
LDraw.org Discussion Forums
›
Administrative
›
Website Suggestions/Requests/Discussion
LDraw Parts Tracker now uses LDView
LDraw Parts Tracker now uses LDView
LDraw Parts Tracker now uses LDView
« Next Oldest | Next Newest »
| Messages In This Thread |
|
LDraw Parts Tracker now uses LDView - by Philippe Hurbain - 2011-09-07, 14:59
Re: LDraw Parts Tracker now uses LDView - by Travis Cobbs - 2011-09-07, 15:30
Re: LDraw Parts Tracker now uses LDView - by Don Heyse - 2011-09-07, 16:33
Re: LDraw Parts Tracker now uses LDView - by Travis Cobbs - 2011-09-07, 17:24
Re: LDraw Parts Tracker now uses LDView - by Don Heyse - 2011-09-07, 19:33
Re: LDraw Parts Tracker now uses LDView - by Chris Dee - 2011-09-08, 6:09
|
Users browsing this thread: 1 Guest(s)