LPub: Part Lengths

LPub: Part Lengths
What discriminator does LPub use to determine the lengths of parts? Some parts such as Technic beams and axles will display a length in the Parts List. However, other parts such as Technic bricks and 1/2 width beams do not. Is there any way for me to edit the part files to enable this, or is it hard coded into LPub? I do a lot of Technic instructions and it is often quite difficult to tell from a PLI whether a 14L or 16L brick is used, for example.
« Next Oldest | Next Newest »

Messages In This Thread
LPub: Part Lengths - by Eric Albrecht - 2012-08-02, 19:19
Re: LPub: Part Lengths - by Gerald Lasser - 2013-05-08, 13:07
RE: LPub: Part Lengths - by Steffen - 2018-04-03, 17:36
RE: LPub: Part Lengths - by Merlijn Wissink - 2018-04-03, 18:32

Forum Jump:

Users browsing this thread: 1 Guest(s)