Yes, maybe in the final part I'll probably scale up the stud4a... This was written more to document an idea I had than to show the real part design.
LDraw.org Discussion Forums
›
Models and Parts
›
Parts Authoring
Tutorial: joining studs to a non-planar surface
Tutorial: joining studs to a non-planar surface
Tutorial: joining studs to a non-planar surface
« Next Oldest | Next Newest »
| Messages In This Thread |
|
Tutorial: joining studs to a non-planar surface - by Philippe Hurbain - 2012-01-15, 12:41
Re: Tutorial: joining studs to a non-planar surface - by Jean-Philippe Ouellet - 2012-01-15, 18:00
Re: Tutorial: joining studs to a non-planar surface - by Philippe Hurbain - 2012-01-15, 19:19
Re: Tutorial: joining studs to a non-planar surface - by Tim Gould - 2012-01-15, 21:42
Re: Tutorial: joining studs to a non-planar surface - by Philippe Hurbain - 2012-01-16, 7:53
Re: Tutorial: joining studs to a non-planar surface - by Tim Gould - 2012-01-16, 9:31
Re: Tutorial: joining studs to a non-planar surface - by Travis Cobbs - 2012-01-16, 21:30
|
Users browsing this thread: 1 Guest(s)