BFCing


Re: BFCing
#8
I have a few questions concerning BFC.
First of all: What does BFC stand for?
Does the orientation concern the part only or the pattern also? Since I'm just doing patterns I don't know if I have to do anything. I looked at the part in LDView in BFC Mode but I don't have a clue what I'm looking at. Could someone enlighten me, please?


Attached Files
.dat   973pr3.dat (Size: 59.55 KB / Downloads: 0)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
BFCing - by Steffen - 2012-01-09, 1:17
Re: BFCing - by Orion Pobursky - 2012-01-09, 4:09
Re: BFCing - by Philippe Hurbain - 2012-01-09, 11:19
Re: BFCing - by Steffen - 2012-01-09, 12:45
WINDZ 0.1.0 bug list - by Steffen - 2012-01-09, 12:58
Re: BFCing - by Daniel Goerner - 2012-03-13, 10:36
Re: BFCing - by Philippe Hurbain - 2012-03-13, 11:00
Re: BFCing - by Daniel Goerner - 2012-03-13, 12:04
Re: BFCing - by Philippe Hurbain - 2012-03-13, 13:49
Re: BFCing - by Tore Eriksson - 2012-03-13, 15:15
Re: BFCing - by Chris Dee - 2012-03-13, 20:35
Re: BFCing - by Tim Gould - 2012-03-13, 20:40
RE: BFCing - by Steffen - 2018-04-02, 9:53
Re: BFCing - by Daniel Goerner - 2012-05-02, 21:52
Re: BFCing - by Steffen - 2012-05-03, 0:04
Re: BFCing - by Daniel Goerner - 2012-05-03, 0:58
Re: BFCing - by Philippe Hurbain - 2012-05-03, 7:03
Re: BFCing - by Steffen - 2012-05-03, 11:17
Re: BFCing - by Philippe Hurbain - 2012-05-03, 12:26
Re: BFCing - by Steffen - 2012-05-03, 13:10
Re: BFCing - by Daniel Goerner - 2012-05-03, 15:40

Forum Jump:


Users browsing this thread: 2 Guest(s)