System and Studless Techinc Standards Problem


Re: System and Studless Techinc Standards Problem
#2
I agree that there is a problem for a few pieces such as this one, but I don't see a good solution avoiding rewriting all Technic parts...
For this specific part I don't see such a big problem with present solution but I wouldn't object if it was modelled with a sloped top on liftarm section to have the tip 18ldu wide.
Quote:2) We model technic holes at 10LDU from the top of a brick, which is slightly too low (9LDU is closer).
According to LDD models, it's exactly 9.5 ldu.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Re: System and Studless Techinc Standards Problem - by Philippe Hurbain - 2012-01-01, 20:42

Forum Jump:


Users browsing this thread: 1 Guest(s)