replacing the filename with the file data but getting no graphical data

[SNIPE]

Hi,

If you load in a file data to a project, how do you edit the part colour like you would if you were to edit an entire sub part, for example by typing:
'1 16 0 -4 0 6 0 0 0 1 0 0 0 6 4-4disc.dat'
The '4-4'stud.dat' part is replaced by the file data, and that file data is listed below:

3 16 0 0 0 1 0 0 0.9239 0 0.3827
3 16 0 0 0 0.9239 0 0.3827 0.7071 0 0.7071
3 16 0 0 0 0.7071 0 0.7071 0.3827 0 0.9239
3 16 0 0 0 0.3827 0 0.9239 0 0 1
3 16 0 0 0 0 0 1 -0.3827 0 0.9239
3 16 0 0 0 -0.3827 0 0.9239 -0.7071 0 0.7071
3 16 0 0 0 -0.7071 0 0.7071 -0.9239 0 0.3827
3 16 0 0 0 -0.9239 0 0.3827 -1 0 -0
3 16 0 0 0 -1 0 -0 -0.9239 0 -0.3827
3 16 0 0 0 -0.9239 0 -0.3827 -0.7071 0 -0.7071
3 16 0 0 0 -0.7071 0 -0.7071 -0.3827 0 -0.9239
3 16 0 0 0 -0.3827 0 -0.9239 0 0 -1
3 16 0 0 0 0 0 -1 0.3827 0 -0.9239
3 16 0 0 0 0.3827 0 -0.9239 0.7071 0 -0.7071
3 16 0 0 0 0.7071 0 -0.7071 0.9239 0 -0.3827
3 16 0 0 0 0.9239 0 -0.3827 1 0 0
0

I can save the filename as newstud.dat for example

When I type this file data and the string '1 16 0 -4 0 6 0 0 0 1 0 0 0 6' to edit the whole part I just get a white screen when I save it and open it in the grapical display panel.

any ideas?