Question about subparts (3626bs01, 3626cs01)

[Manfred Schaefer]

The content in 3626bs01 can't be changed or edited, due to backward compatibility reasons.
There is nothing stopping us from creating a new subfile emulating something similar.

But I wonder why?
The content is easy to make using just 2 other subfiles.

Code:

1 16 0 0 0 1 0 0 0 1 0 0 0 1 s\3626bs02.dat
1 16 0 0 0 1 0 0 0 1 0 0 0 1 s\3626bs04.dat

Hello,

The necessity of this measure can be discussed.
The question now is why was 3626cs01 created?
If I wanted to create a Minfig Head with only a printed front face, then I would take an existing file as a basis and make my changes.
Currently however, I do not have enough experience to do this.
From my point of view, a subpart that combines the two subfiles 3626bs02 and 3626bs04 is not necessary.
I just wasn't aware of the reason. It was probably done that way in the past and would not be done that way today.

Regards

Manfred