As far as I'm aware, there is no way to mark surfaces on parts as "grainy", an effect most commonly known from 2x2 slope bricks. I think it would be good to have such thing, especially for being able to distinguish some possible clean and grainy variants (there are some iirc, but I might be wrong)
LDraw.org Discussion Forums
›
General
›
Official File Specifications/Standards
Grainy surface marking
Grainy surface marking
Grainy surface marking
« Next Oldest | Next Newest »
| Messages In This Thread |
|
Grainy surface marking - by Max Murtazin - 2022-04-01, 9:54
RE: Grainy surface marking - by N. W. Perry - 2022-04-01, 13:17
RE: Grainy surface marking - by Matthew Morrison - 2022-04-01, 22:54
RE: Grainy surface marking - by Max Murtazin - 2022-04-01, 23:21
RE: Grainy surface marking - by N. W. Perry - 2022-04-02, 3:08
|
Users browsing this thread: 1 Guest(s)