From Willy: Define a standard for helper parts


From Willy: Define a standard for helper parts
#1
The following was posted by Willy Tschager in the Standards Board forum. In my opinion, that was not the right place for it, so I am starting a thread here.

(2021-08-13, 11:18)Willy Tschager Wrote: Guys,

in response to this post:

https://forums.ldraw.org/thread-24732.html

the majority of the SteerCo is in favour to add helper parts to the library but before a final vote we would like you to define a standard for these parts such as:

Naming convention
Category
Edges Yes/No on 2D helpers
Edges Yes/No on 3D helpers

The general idea would be to add these to the main library as the separate Alias and Physical parts library hasn't worked very well. In addition these parts shouldn't go through the PT for certification but be usable in all editors. Any input from your side is welcome.

Some example of helpers can be found here:

http://www.holly-wood.it/ldraw/helper-en.html

w.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
From Willy: Define a standard for helper parts - by Travis Cobbs - 2021-08-18, 23:53

Forum Jump:


Users browsing this thread: 1 Guest(s)