LDCad Part Connectivity


RE: Part Connectivity
#6
(2021-08-05, 17:55)Miguel Reizinho Wrote: I'm using Stud.io Part Designer, not sure if it is a 'real' editor. Smile 
It depends if you want to make proper LDraw parts (you can donate to the library) or just custom ones for use in studio/LDCad

(2021-08-05, 17:55)Miguel Reizinho Wrote: This is getting to be an addition (part 65578 was driving me nuts!). How can I contribute to the official LDCad shadow library? 
Once it is part of the LDraw (un)official library you can mail me the snap definitions or post it here.

(2021-08-05, 17:55)Miguel Reizinho Wrote: This is getting to be an addition (part 65578 was driving me nuts!). How can I contribute to the official
Also can you clarify for me please: for my unofficial parts library, I had no file or folder configured for the shadow library. So where did LDCad saved my shadow files?
If your part isn't loaded from a library location with a shadow, snap information will be added to the part file itself.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Part Connectivity - by Miguel Reizinho - 2021-08-01, 19:06
RE: Part Connectivity - by Roland Melkert - 2021-08-01, 19:41
RE: Part Connectivity - by Miguel Reizinho - 2021-08-02, 15:57
RE: Part Connectivity - by Roland Melkert - 2021-08-03, 22:01
RE: Part Connectivity - by Miguel Reizinho - 2021-08-05, 17:55
RE: Part Connectivity - by Roland Melkert - 2021-08-05, 19:26

Forum Jump:


Users browsing this thread: 1 Guest(s)