LDCad Part Connectivity


RE: Part Connectivity
#5
(2021-08-03, 22:01)Roland Melkert Wrote: Yes just move all the sub parts around until the desired part center is at 0,0,0

But you will need a 'real' LDraw part editor as LDCad only allows editing of the shadow data.

I'm using Stud.io Part Designer, not sure if it is a 'real' editor. Smile 

And I was able to define the part center by placing the part at 0,0,0. Thank you. 

This is getting to be an addition (part 65578 was driving me nuts!). How can I contribute to the official LDCad shadow library? 

Also can you clarify for me please: for my unofficial parts library, I had no file or folder configured for the shadow library. So where did LDCad saved my shadow files?
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Part Connectivity - by Miguel Reizinho - 2021-08-01, 19:06
RE: Part Connectivity - by Roland Melkert - 2021-08-01, 19:41
RE: Part Connectivity - by Miguel Reizinho - 2021-08-02, 15:57
RE: Part Connectivity - by Roland Melkert - 2021-08-03, 22:01
RE: Part Connectivity - by Miguel Reizinho - 2021-08-05, 17:55
RE: Part Connectivity - by Roland Melkert - 2021-08-05, 19:26

Forum Jump:


Users browsing this thread: 1 Guest(s)