Sprocket Wheel 57519 Alignment of Centre Pin Holes incorrect


RE: Sprocket Wheel 57519 Alignment of Centre Pin Holes incorrect
#2
(2021-02-08, 22:19)GeraldĀ Lasser Wrote: From a post over at Stud.io, the six centre pinholes are rotated by 90 dregrees.

So the correct code for the interior is

1 16 0 0 0 0 1 0 -1 0 0 0 0 1 s\57519s02.dat
1 16 0 0 0 .866 .5 0 -.5 .866 0 0 0 1 s\57519s02.dat
1 16 0 0 0 .866 -.5 0 .5 .866 0 0 0 1 s\57519s02.dat
1 16 0 0 0 0 -1 0 1 0 0 0 0 1 s\57519s02.dat
1 16 0 0 0 -.866 -.5 0 .5 -.866 0 0 0 1 s\57519s02.dat
1 16 0 0 0 -.866 .5 0 -.5 -.866 0 0 0 1 s\57519s02.dat


What should we do with it? Create a "b" file?

The original file might have pins or axles in place that won't fit any longer if we change it.
If I am not utterly wrong, you get the same result with a 90Ā° rotation of the whole wheel Wink
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Sprocket Wheel 57519 Alignment of Centre Pin Holes incorrect - by Philippe Hurbain - 2021-02-09, 9:26

Forum Jump:


Users browsing this thread: 1 Guest(s)