LDCad Some Gear Rotations are "disconnected"

RE: Some Gear Rotations are "disconnected"
(2020-10-18, 7:23)NikosSprocket Wrote: Another example for 3648b I can only rotate the hub but not the teeth.

If you go with the default option of 15 degrees the teeth will visually not rotate, cause there is one tooth each 15 degrees. ;-)

If you want to adjust the gears correctly, you need to calculate them separately as written in another post.
As I do this always you can just search for a technic model done by me in the OMR. ;-)
« Next Oldest | Next Newest »

Messages In This Thread
RE: Some Gear Rotations are "disconnected" - by Max Martin Richter - 2020-10-21, 8:45

Forum Jump:

Users browsing this thread: 1 Guest(s)