New Click hinges

[Philippe Hurbain]

I noticed these hinges the first time in the Vidiyo Sets. The 4 x 6 Plate with two hinges has a "clh6" that on one side opens to the top, and on the other side opens to the bottom.

I would propose the following to prims:


should I construct them from common elements, like subfiling clh6?

EDIT: Also our part 44568 is wrong, it uses twice the clh6, but the fingers are the same as in 65133

So this update is not new at all, 44568 is a 2003 part... Is this really needed to address this "problem" now?
Anyway if you modify clh6, please switch rounded bevels to 8\ primitives (or even make sharp edges, like was done for 1x1 round tile...)