New Click hinges


RE: New Click hinges -
#2
I noticed these hinges the first time in the Vidiyo Sets. The 4 x 6 Plate with two hinges has a "clh6" that on one side opens to the top, and on the other side opens to the bottom.

I would propose the following to prims:
   

should I construct them from common elements, like subfiling clh6?

EDIT: Also our part 44568 is wrong, it uses twice the clh6, but the fingers are the same as in 65133
Reply
« Next Oldest | Next Newest »



Messages In This Thread
New Click hinges - by Orion Pobursky - 2020-08-05, 17:57
RE: New Click hinges - - by Gerald Lasser - 2021-03-09, 23:21
RE: New Click hinges - - by Philippe Hurbain - 2021-03-10, 18:03
RE: New Click hinges - - by Gerald Lasser - 2021-03-10, 21:18
RE: New Click hinges - by Gerald Lasser - 2021-03-13, 22:45
RE: New Click hinges - by Magnus Forsberg - 2021-03-14, 7:51
RE: New Click hinges - by Philippe Hurbain - 2021-03-14, 8:17
RE: New Click hinges - by Gerald Lasser - 2021-03-14, 10:39
RE: New Click hinges - by Magnus Forsberg - 2021-03-14, 10:52
RE: New Click hinges - by Philippe Hurbain - 2021-03-14, 13:24
Click hinge descriptions - by Magnus Forsberg - 2022-11-11, 20:36

Forum Jump:


Users browsing this thread: 1 Guest(s)