LDPE 0.8.50 Beta Released (bugfix / usability)


Rounding problem
#13
"sometimes", rotation of an element result in excessive number of digits. When you try to apply rounding tool to that result, nothing happen.

Example of such line:
Code:
1 16 .00000000000000000000000000000212293491784143431108835 70.000000000000000000000000000001 -10.000000000000000000000000000032 -3.0614674589207171555441788133124 0 7.3910362600902944708123019945409 7.3910362600902944708123019945409 0 3.0614674589207171555441788133124 0 16 0 1-8edge.dat

Basically, this was obtained by rotating with a 22.5° angle step the following line after setting manipulator to primitive.
Code:
1 16 0 70 -10 0 0 -8 -8 0 0 0 16 0 1-8edge.dat
...but I said "sometimes" because when I try this again it does work (the rotated line has a normal number of digits and rounds properly...
Code:
1 16 -.00000000000000000000000000001 69.999999999999999999999999999996 -10 -3.0614674589207171555441788133124 0 7.391036260090294470812301994541 7.391036260090294470812301994541 0 3.0614674589207171555441788133124 0 16 0 1-8edge.dat


Edit: Problem is more subtle than it seemed at first: after the editions I made to document the bug here, I was able to round the first line properly Sad
Reply
« Next Oldest | Next Newest »



Messages In This Thread
What was reported? - by Nils Schmidt - 2020-06-02, 19:59
Rounding problem - by Philippe Hurbain - 2020-07-12, 13:19

Forum Jump:


Users browsing this thread: 1 Guest(s)