Official Library File Format Restictions


RE: Official Library File Format Restictions
#52
IMHO concerning the part naming when it comes to dimensions, e.g. if it is 2 plates high, it will be .667, this was change in the past from 2/3 to this, I think it should be added and also how many decimals shall there be in the description (3).

Also:
anything Bricklike: Studs x Studs x Bricks
anything Technic looking: Studs x Studs x Studs

Where is the orientation of a part taken care of?
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Official Library File Format Restictions - by Gerald Lasser - 2020-07-02, 13:19

Forum Jump:


Users browsing this thread: 1 Guest(s)