[LDCad] Problem exporting model to ldd

[Roland Melkert]

Only this time I’m missing 142 bricks in ldd, because they can’t be loaded.

LDD can be extremly picky at this, but far I know you should be ok when using the default grid or part snapping in LDCad

Did you use a very fine grid while 'eying' it. This shouldn't be necessary as most bricks are aligned to multitudes of 10 (width and dept) and 8 (height). This is also the default grid stepping.

Using a fine grid might have placed things a fraction to far, which LDD won't tolerate.

You could try to select all and while the default grid is active (press 3 while the mouse is in the editing area) use the  placement/snap all to grid option from the right click selection menu.

But many parts might need manual adjusting afterwards.