Complete 25195 Plate, Modified 2 x 6 with Pole Holder Pin


RE: 25195 Plate, Modified 2 x 6 with Pole Holder Pin
#5
(2020-04-15, 17:15)Magnus Forsberg Wrote: Maybe I could use an inverted subfile, s\23421s01.dat ?
But I think it might not be that complex, or long? Must be something shorter, with less friction?

Found the bottom in a video review.



Looks like the inside is smaller than a regular bottom stud.
But the spiral pole is 12 ldu diameter.
I have found a copy of that polybag in my storage. The part has 3 indents inside of the cylinder. I can take some pictures and measurements after work, unless you have found a better source.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: 25195 Plate, Modified 2 x 6 with Pole Holder Pin - by Lasse Deleuran - 2020-04-15, 17:39

Forum Jump:


Users browsing this thread: 1 Guest(s)