LDCad How to add a flexible Powered Up Cable

How to add a flexible Powered Up Cable

I'm trying to get a Powered Up train motor with a flexible cable into my .mpd so I can build instructions showing where to run the cable.  

As far as I can tell, the Powered Up Train motor is not available in LDraw, but the Power Functions train motor (unofficial 87574) is a good approximation.  However this part does not have a cable and plug.  I understand a bit about how flexible parts work in LDCad, but I can't seem to find the right part to use to generate the cable.  None of the parts I have found seem to allow me to add guide points.  So two questions:

1)  Is adding a flexible cable to 87574 the right approach?
2)  What part do I use to serve as the basis for the cable that I can stretch?


« Next Oldest | Next Newest »

Messages In This Thread
How to add a flexible Powered Up Cable - by CJ H. - 2020-02-13, 16:44

Forum Jump:

Users browsing this thread: 1 Guest(s)