Problem using Minifig Legs Dual Mould in Studio


RE: Problem using Minifig Legs Dual Mould in Studio
#2
(2020-02-11, 17:17)AlastairĀ W Wrote: Hi all

I'm attempting to use partĀ 21019 (Minifig Hips and Legs Dual Mould with Uncoloured Lower Leg Pattern) in BrickLink Studio.
My objective is to have flesh coloured upper legs and black or brown lower legs to emulate boots. The upper part of the legs will be covered by a skirt.

Anyhow, I have discovered that this part consists of many subparts and I can import them one-by-one into Studio.
However, the right leg appears to consist of left leg parts and I'm unable to make a mirror copy.
You can see what I mean here:
https://www.ldraw.org/official-part-look...461p05.dat
The subparts are all for a left leg!

So I'm rather confused and probably not even taking the correct approach.
Any assistance you could give would be greatly appreciated.
Many thanks in advance!
Alastair

I have no direct answer but can one import LDraw geometry in Studio?
Then could you inline all subparts and import that part?
Jaco van der Molen
lpub.binarybricks.nl
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Problem using Minifig Legs Dual Mould in Studio - by Jaco van der Molen - 2020-02-12, 11:27

Forum Jump:


Users browsing this thread: 1 Guest(s)