Thinking about doing a LDCad 1.7 version


RE: Thinking about doing a LDCad 1.7 version
#62
I've noticed that sometime when I snap something (especially a bunch of things at once) to grid or reset the orientation that it doesn't snap all the way but instead gets very close (the largest error I've seen is 0.01 on position, the matrix is usually super close like 0.0001)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Thinking about doing a LDCad 1.7 version - by Orion Pobursky - 2020-02-19, 0:48

Forum Jump:


Users browsing this thread: 1 Guest(s)