LDCad Part Snapping missing/errors


RE: Part Snapping missing/errors
For part 41682 (Bracket 2 x 2 - 1 x 2 Up Centred), I can't seem to attach to the back of the vertical plate. The front of the vertical plate is fine.

From playing around a bit, I think that this line:

0 !LDCAD SNAP_CYL [gender=F] [caps=one] [secs=S 6 4] [pos=0 -10 0] [ori=1 0 0 0 0 1 0 -1 0] [grid=C 2 1 20 0]

should be:

0 !LDCAD SNAP_CYL [gender=F] [caps=one] [secs=S 6 4] [pos=0 -10 4] [ori=-1 0 0 0 0 1 0 1 0] [grid=C 2 1 20 0]

Regards,

David
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Part Snapping missing/errors - by David Manley - 2022-03-07, 6:48
RE: Part Snapping missing/errors - by SNIPE - 2022-07-22, 13:59

Forum Jump:


Users browsing this thread: 2 Guest(s)