LDCad Part Snapping missing/errors


RE: Part Snapping missing/errors
6587 (axle 3 with stud) snapping currently uses an axle meta with round section to make the stud. But this is wrong since the axle meta forces orientation of plate/tile placed on stud (moreover the hole in stud is not modeled).
Correction:
Code:
0 !LDCAD SNAP_CYL [gender=M] [caps=none] [secs=A 6 58   R 8 2] [center=true] [slide=true] [ori=0 -1 0 1 0 0 0 0 1]
0 !LDCAD MIRROR_INFO [baseFlip=Z] [counterPart=self]
instead of
Code:
0 !LDCAD SNAP_CLEAR
0 !LDCAD SNAP_CYL [gender=M] [caps=none] [secs=A 6 58   R 8 2   R 6 4] [center=true] [slide=true] [pos=2 0 0] [ori=0 -1 0 1 0 0 0 0 1]
0 !LDCAD MIRROR_INFO [baseFlip=Z] [counterPart=self]
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Part Snapping missing/errors - by Philippe Hurbain - 2021-11-30, 9:34
RE: Part Snapping missing/errors - by SNIPE - 2022-07-22, 13:59

Forum Jump:


Users browsing this thread: 4 Guest(s)