LDCad Part Snapping missing/errors

RE: Part Snapping missing/errors
(2021-10-01, 20:07)N. W. Perry Wrote: I was thinking of something like the SLIDE property, where it snaps in one place but can then freely rotate.

You could fake that by using a square or axle SNAP_CYL pair, to force the 'teeth' inline with he nudges inside the hub connector (those connections are forced at 90 deg rotation).

The snap meta on 2907 will still need a 22.5 deg rotate to force the offset as the current official part doesn't align at rest.
« Next Oldest | Next Newest »

Messages In This Thread
RE: Part Snapping missing/errors - by Roland Melkert - 2021-10-01, 20:27
RE: Part Snapping missing/errors - by SNIPE - 2022-07-22, 13:59

Forum Jump:

Users browsing this thread: 1 Guest(s)