8865 Test Car
2019-11-27, 21:27 (This post was last modified: 2019-11-27, 21:29 by Stefan Frenz. Edit Reason: typos )
2019-11-27, 21:27 (This post was last modified: 2019-11-27, 21:29 by Stefan Frenz. Edit Reason: typos )
Hi there,
this time it's the 1988's Test Car Technic model 8865. It should be OMR compliant, but there are known issues:
- Small mismatch for 16-technic-brick (3703) which connects the front frame to the roof in the last step. As far as I can see and calculate with CAD, this seems to be "desired margin" in the real build. Did I something wrong, is there a way to make it look "better matching"?
- The steering axle angles with two universal joint (2x 3712+3326b+3712) in steps 16/17 are not acceptable. I looked at the angles provided by "Selection Info" without luck - I will fix this as soon as possible and would welcome any suggestion.
Done with LDCad 1.6c (Linux64).
Thanks in advance for any improvement suggestion!
Regards
Stefan
this time it's the 1988's Test Car Technic model 8865. It should be OMR compliant, but there are known issues:
- Small mismatch for 16-technic-brick (3703) which connects the front frame to the roof in the last step. As far as I can see and calculate with CAD, this seems to be "desired margin" in the real build. Did I something wrong, is there a way to make it look "better matching"?
- The steering axle angles with two universal joint (2x 3712+3326b+3712) in steps 16/17 are not acceptable. I looked at the angles provided by "Selection Info" without luck - I will fix this as soon as possible and would welcome any suggestion.
Done with LDCad 1.6c (Linux64).
Thanks in advance for any improvement suggestion!
Regards
Stefan